08 March 2021

EF80, EF183, EF184 XTAL oscillator

While passing through forgotten boxes of forgotten components looking for some interesting TTL/CMOS ICs for an artistic project, I found two large XTALs for 2.0971 MHz. I think they were meant for some valve circuit, so I looked for an oscillator circuit with one of the tubes I have most: EF80.

Using the DIY B9A base I rigged together the most promising circuit I found online of a CW TX, with resistors "close enough" to quoted values. The ugly result is shown in the picture as well as the circuit diagram.


Diagram and test circuit.
 

I fed 6Vdc to the filament and 150V HT and it did oscillate. Cool. Time for experiments.

I could reduce filament to 5V at 300mA and everything was fine.

I could reduce the HT to 30V and it didn't stop oscillating, alas the signal picked up by the nearby receiver was much weaker. I couldn't go with a lower HT with today test setup.

Then, while I was at it, I tested all EF80 valves I had already separated from the rest. Not happy with the result, I checked through the list and found out that EF183 and EF184 pentodes are pin-compatible with EF80, so they got tested too. I could even re-stamp a few tubes that had become anonymous.

The result of a couple of hours of fiddling with on/off switched of power supplies is that I have 28 working pentodes waiting to be used in a real transmitter.

Now: VFO or XTAL?